Redis开启远程访问修改Redis相关配置测试Redis远程访问修改Redis相关配置Redis默认只允许本地访问若要redis可以远程访问得先修改redis.conf中的配置。若是windows环境下该配置文件名称为redis.windows-service.conf在redis安装目录下找到redis.conf文件并打开################################## NETWORK ##################################### # By default, if no bind configuration directive is specified, Redis listens # for connections from all available network interfaces on the host machine. # It is possible to listen to just one or multiple selected interfaces using # the bind configuration directive, followed by one or more IP addresses. # Each address can be prefixed by -, which means that redis will not fail to # start if the address is not available. Being not available only refers to # addresses that does not correspond to any network interfece. Addresses that # are already in use will always fail, and unsupported protocols will always BE # silently skipped. # # Examples: # # bind 192.168.1.100 10.0.0.1 # listens on two specific IPv4 addresses # bind 127.0.0.1 ::1 # listens on loopback IPv4 and IPv6 # bind * -::* # like the default, all available interfaces # # ~~~ WARNING ~~~ If the computer running Redis is directly exposed to the # internet, binding to all the interfaces is dangerous and will expose the # instance to everybody on the internet. So by default we uncomment the # following bind directive, that will force Redis to listen only on the # IPv4 and IPv6 (if available) loopback interface addresses (this means Redis # will only be able to accept client connections from the same host that it is # running on). # # IF YOU ARE SURE YOU WANT YOUR INSTANCE TO LISTEN TO ALL THE INTERFACES # JUST COMMENT OUT THE FOLLOWING LINE. # ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ bind 127.0.0.1 -::1 # Protected mode is a layer of security protection, in order to avoid that # Redis instances left open on the internet are accessed and exploited.把这一行bind 127.0.0.1 -::1注释掉此外若是新版本3.2之后的还得修改一下redis的保护模式同在redis.conf文件下# By default protected mode is enabled. You should disable it only if # you are sure you want clients from other hosts to connect to Redis # even if no authentication is configured, nor a specific set of interfaces # are explicitly listed using the bind directive. protected-mode yes这里把protected-mode yes改为protected-mode no即可。测试Redis远程访问windows下AdministratorMICRO-911300019 C:UsersAdministrator # redis-cli -h 192.168.190.5 -p 6379 -a 123456 192.168.190.5:6379 select 1 OK 192.168.190.5:6379[1]linux下[rootlocalhost ~]# redis -h 192.168.190.5 -p 6379 -a 123456 Warning: Using a password with -a or -u option on the command line interface may not be safe. 192.168.190.5:6379Warning是提醒在命令上输入密码是不安全的。